This is an on-going project, with be keep updated.
IKEA SKADIS MODULAR SYSTEMA modular pegboard for desktop and more, this is an on-going project, more sizes and components will keep coming out, you can also leave in the comments for what you wish to have. V1.0:9 sizes of pegboards, steps with 240, 160 and 80mmsome basic componentsI used the clips from @LineArcLine on printablesIMPORTANT NOTE: ALL FLAT CONNECTORS NEED TO BE USED IN FRONT AND BACK OF THE BOARDS!WICHTIGER HINWEIS: ALLE FLACHVERBINDER MÜSSEN AN DER VORDER- UND RÜCKSEITE DER PLATTEN VERWENDET WERDEN!重要提示：每个连接件需要打印2份，正反面同时使用！ Notes:I tested on X1C and A1 Mini, with BBL PLA Basic and Matte filaments, other filaments have not been tested, please calibrate before print to avoid print failure.slow down the first layer, I setup to 15mm/s for the first layer in my 3mf profile.disable the cooling for the first 3 layers to enhance the adhesive is recommended.I cut out a little piece on 1 corner of 240x240mm board, to avoid the reserved space on X/P series printers, in this case you do not need to change the print volume setting in bambu studio or manually block the cutter pusher. Enjoy your print!
