Secure your accessories on the IKEA Skadis board effectively with this tailored plug set.
These plugs prevent unintentional detachment and sliding by fitting into a top hole partially obscured by the accessory.
Available in sizes ranging from 2mm to 15mm, they accommodate a wide range of accessories.
I provide two options: with or without a handle.
The version including a handle simplifies installation and removal but demands additional clearance, which may not be compatible with certain accessories.
Moreover, this variant is more challenging to print and less discreet once installed.
For these reasons, I personally favor the flat variant.
Current limitations: The accessory must partially cover a hole on the top edge.
The obscured hole’s height should be between 2mm and 15mm.
Future updates will address these limitations.
Please be aware that the regular version needs 5mm of clearance towards the front for the handle, use the flat variant (separate print profile) s can be time-consuming and may not always be possible, leading to the creation of this simple, universal (within current constraints), and easily printable solution.
Printing Instructions Brims are added for improved adhesion due to the delicacy of the plugs.
Carefully remove the brim to avoid damaging the plug.
While PETG is recommended for its properties, PLA has been tested and found satisfactory.
Handle gently to maintain integrity.
Skadis Collection I am constantly developing more IKEA Skadis attachments.
Check out my IKEA Skadis Collection here.
