Original Source Material: – Original Creator Ikea Samla Foam Clips: 3Dpartmaker on Thingiverse. – Original Creator Ikea Samla Silicagel Box: Grizmo on Thingiverse. – Original Creator Ikea Samla Drybox Sensor Mount: RoboMagus on Thingiverse. – Original Creator Ikea Samla Gliding Feet: Physicator on Thingiverse. – Original Creator 10 mm Rod Holder: CCoonz on Thingiverse.
Please support all these great designers!
Thank you for your work!
Description: A remix & share for a complete Filament Storage Box by using multiple models from multiple sources.
A Ikea Samla 22L box is used, as these are available around the globe.
I edited the 10 mm Rod Holder to fit my specific needs.
I have multiple Ikea Samla boxes that use this complete setup to keep my filaments free from dust and moisture.
Also, Gliding Feet are added to the Samla Box to avoid damaging the floor and to easily move the boxes around.
The 10 mm rod holders have been remixed by me to make it able to use in combination with the Silicagel Box.
The rod holder was edited in Tinkercad for that.
It was firstly uploaded on Printables on 24-04-2023.
To complete this setup, you will need to buy some extra stuff: – 4x M3 Nut. – Self-adhesive foam tape for extra sealing the lid. – Doublesided self-adhesive tape for mounting the rod holders. – A round hydrometer.
These can be bought cheap on Alieexpress.
Some small instructions on some of the printable parts:
——————————
Ikea Samla Foam Clips
——————————
Please add a brim to the printing profile when printing the clips for good adhesion to you build plate.
Otherwise, the print may fail!
——————————
Ikea Samla Drybox Sensor Mount
——————————
M3 Bolt have quite a tight fit.
Use some pliers to force the M3 nut in.
Use a 3 mm drill for drilling the holes in the Samla box.
——————————
Ikea Samla 10 mm Rod Holder
——————————
– The printing profile has Brim turn off by default.
I would highly recommend to use a brim when printing the clips.
If there are more suggestions for better settings, please upload them! – White: eSUN PLA+ Cold White. – Grey: eSUN PLA+ Grey.
