Was looking for a drybox and found the IKEA 365+ 10,6l container and @Twotone74 already designed a spool holder for it.I did a quick and dirty remix to it, to better fit my needs:made it symmetrical, original it was 65+85mm, now it is 75+75mm Rollsresized the hole for the bearings, it was a big to bitadded a version of the roll for use without bearingsangled the underside edge to 35° so it’s easier to printmade a lid for the silica containerresized the slot for the hygrometer (affiliate link), it’s now a bit wider and without cutouts for the tabs, now all versions of the hygrometer should snap in, regardless of their tab positioning and you can just rotate it into correct orientationYou will need 8x 608 bearings (affiliate link) and 1xM3 screw for the silica lid.
