Ikea Skadis AA/AAA battery holder

Simple AA/AAA battery holder for IKEA Skadis, quick to print and uses very little filament.

Printing: 4x clip battery holder R side to be printed as attached, L side to be mirrored in the slicer along X axis Capacity: AAA = 29 batteries AA = 20 batteries Assembly: slide in the clips into openings on each side of the holder, make sure the clips surface is flat with the main body push both sides onto skadis board, the tolerances are pretty tight so you might need to use a bit force Check out my other accessories for Ikea Skadis board: CR123a Battery holder Cable Clips Tablet Mount Motion Sensor Mount